What size drill for an M30 tap?

Short answer: 26.5 mm drill (1.0433 in, 26.50 mm). That is D − P (30 − 3.5 mm) and gives about 77% thread. Closest inch drill: 1-3/64 in (1.0469 in, 75% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M30 tapped hole drawn to scale: drill 26.5 mm, thread major diameter 30.00 mm20 mm
26.5mm26.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.0433
Millimetres
26.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M30 tap drill sizes from 50% to 85% thread

DrillInchmmThread
27.5 mm1.082727.5055%
27 mm1.063027.0066%
26.5 mmRecommended1.043326.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M30 bolt

FitDrillInchmm
Close31 mm1.220531.00
Normal33 mm1.299233.00
Loose35 mm1.378035.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M30 thread dimensions

DimensionInchmm
Major diameter (basic)1.181130.00
Pitch diameter (basic)1.091627.73
Minor diameter, internal (basic)1.031926.21
Pitch0.13783.50

Metric coarse (ISO), 3.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M30 x 3.5 tapPlug tap for through holes, bottoming tap for blind holes
26.5 mm drill bit1.0433 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M30 tap? Use a 26.5 mm drill for an M30 x 3.5 tap (77% thread). The closest inch drill is 1-3/64 (1.0469 in, 75% thread).
M30 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M30 tap?

26.50 mm (1.0433 in). That is the major diameter minus the pitch (30 − 3.5 mm) and gives about 77% thread.

Can I use an inch drill for an M30 tap?

Yes: 1-3/64 in drill (1.0469 in, 26.59 mm) gives about 75% thread.

What is the clearance hole for an M30 bolt?

ISO 273: close fit 31.00 mm, normal fit 33.00 mm, loose fit 35.00 mm.

What does M30 x 3.5 mean?

A 30 mm nominal diameter ISO metric thread with a 3.5 mm pitch (coarse series).