What size drill for an M3 tap?

Short answer: 2.5 mm drill (0.0984 in, 2.50 mm). That is D − P (3 − 0.5 mm) and gives about 77% thread. Closest inch drill: #40 (0.0980 in, 79% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M3 tapped hole drawn to scale: drill 2.5 mm, thread major diameter 3.00 mm2 mm
2.5mm2.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.0984
Millimetres
2.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M3 tap drill sizes from 50% to 85% thread

DrillInchmmThread
2.65 mm0.10432.6554%
2.6 mm0.10242.6062%
2.55 mm0.10042.5569%
2.5 mmRecommended0.09842.5077%
2.45 mm0.09652.4585%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M3 bolt

FitDrillInchmm
Close3.2 mm0.12603.20
Normal3.4 mm0.13393.40
Loose3.6 mm0.14173.60

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M3 thread dimensions

DimensionInchmm
Major diameter (basic)0.11813.00
Pitch diameter (basic)0.10532.68
Minor diameter, internal (basic)0.09682.46
Pitch0.01970.50

Metric coarse (ISO), 0.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

What you'll need

M3 x 0.5 tapPlug tap for through holes, bottoming tap for blind holes
2.5 mm drill bit0.0984 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M3 tap? Use a 2.5 mm drill for an M3 x 0.5 tap (77% thread). The closest inch drill is #40 (0.0980 in, 79% thread).
M3 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M3 tap?

2.50 mm (0.0984 in). That is the major diameter minus the pitch (3 − 0.5 mm) and gives about 77% thread.

Can I use an inch drill for an M3 tap?

Yes: #40 drill (0.0980 in, 2.49 mm) gives about 79% thread.

What is the clearance hole for an M3 bolt?

ISO 273: close fit 3.20 mm, normal fit 3.40 mm, loose fit 3.60 mm.

What does M3 x 0.5 mean?

A 3 mm nominal diameter ISO metric thread with a 0.5 mm pitch (coarse series).