What size drill for an M30x1.5 tap?

Short answer: 28.5 mm drill (1.1220 in, 28.50 mm). That is D − P (30 − 1.5 mm) and gives about 77% thread. Closest inch drill: 1-1/8 in (1.1250 in, 73% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M30x1.5 tapped hole drawn to scale: drill 28.5 mm, thread major diameter 30.00 mm20 mm
28.5mm28.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.1220
Millimetres
28.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M30x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
29 mm1.141729.0051%
28.5 mmRecommended1.122028.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M30 bolt

FitDrillInchmm
Close31 mm1.220531.00
Normal33 mm1.299233.00
Loose35 mm1.378035.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M30x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)1.181130.00
Pitch diameter (basic)1.142729.03
Minor diameter, internal (basic)1.117228.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M30 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
28.5 mm drill bit1.1220 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M30x1.5 tap? Use a 28.5 mm drill for an M30 x 1.5 tap (77% thread). The closest inch drill is 1-1/8 (1.1250 in, 73% thread).
M30x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M30x1.5 tap?

28.50 mm (1.1220 in). That is the major diameter minus the pitch (30 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M30x1.5 tap?

Yes: 1-1/8 in drill (1.1250 in, 28.58 mm) gives about 73% thread.

What is the clearance hole for an M30 bolt?

ISO 273: close fit 31.00 mm, normal fit 33.00 mm, loose fit 35.00 mm.

What does M30 x 1.5 mean?

A 30 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).