What size drill for an M16 tap?

Short answer: 14 mm drill (0.5512 in, 14.00 mm). That is D − P (16 − 2 mm) and gives about 77% thread. Closest inch drill: 35/64 in (0.5469 in, 81% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M16 tapped hole drawn to scale: drill 14 mm, thread major diameter 16.00 mm10 mm
14mm14 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.5512
Millimetres
14.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M16 tap drill sizes from 50% to 85% thread

DrillInchmmThread
14.5 mm0.570914.5058%
14 mmRecommended0.551214.0077%
13.9 mm0.547213.9081%
13.8 mm0.543313.8085%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M16 bolt

FitDrillInchmm
Close17 mm0.669317.00
Normal17.5 mm0.689017.50
Loose18.5 mm0.728318.50

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M16 thread dimensions

DimensionInchmm
Major diameter (basic)0.629916.00
Pitch diameter (basic)0.578814.70
Minor diameter, internal (basic)0.544713.83
Pitch0.07872.00

Metric coarse (ISO), 2 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M16 x 2 tapPlug tap for through holes, bottoming tap for blind holes
14 mm drill bit0.5512 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M16 tap? Use a 14 mm drill for an M16 x 2 tap (77% thread). The closest inch drill is 35/64 (0.5469 in, 81% thread).
M16 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M16 tap?

14.00 mm (0.5512 in). That is the major diameter minus the pitch (16 − 2 mm) and gives about 77% thread.

Can I use an inch drill for an M16 tap?

Yes: 35/64 in drill (0.5469 in, 13.89 mm) gives about 81% thread.

What is the clearance hole for an M16 bolt?

ISO 273: close fit 17.00 mm, normal fit 17.50 mm, loose fit 18.50 mm.

What does M16 x 2 mean?

A 16 mm nominal diameter ISO metric thread with a 2 mm pitch (coarse series).