What size drill for an M20 tap?

Short answer: 17.5 mm drill (0.6890 in, 17.50 mm). That is D − P (20 − 2.5 mm) and gives about 77% thread. Closest inch drill: 11/16 in (0.6875 in, 78% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M20 tapped hole drawn to scale: drill 17.5 mm, thread major diameter 20.00 mm10 mm
17.5mm17.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.6890
Millimetres
17.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M20 tap drill sizes from 50% to 85% thread

DrillInchmmThread
18 mm0.708718.0062%
17.5 mmRecommended0.689017.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M20 bolt

FitDrillInchmm
Close21 mm0.826821.00
Normal22 mm0.866122.00
Loose24 mm0.944924.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M20 thread dimensions

DimensionInchmm
Major diameter (basic)0.787420.00
Pitch diameter (basic)0.723518.38
Minor diameter, internal (basic)0.680917.29
Pitch0.09842.50

Metric coarse (ISO), 2.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M20 x 2.5 tapPlug tap for through holes, bottoming tap for blind holes
17.5 mm drill bit0.6890 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M20 tap? Use a 17.5 mm drill for an M20 x 2.5 tap (77% thread). The closest inch drill is 11/16 (0.6875 in, 78% thread).
M20 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M20 tap?

17.50 mm (0.6890 in). That is the major diameter minus the pitch (20 − 2.5 mm) and gives about 77% thread.

Can I use an inch drill for an M20 tap?

Yes: 11/16 in drill (0.6875 in, 17.46 mm) gives about 78% thread.

What is the clearance hole for an M20 bolt?

ISO 273: close fit 21.00 mm, normal fit 22.00 mm, loose fit 24.00 mm.

What does M20 x 2.5 mean?

A 20 mm nominal diameter ISO metric thread with a 2.5 mm pitch (coarse series).