What size drill for an M45 tap?

Short answer: 40.5 mm drill (1.5945 in, 40.50 mm). That is D − P (45 − 4.5 mm) and gives about 77% thread. Closest inch drill: 1-19/32 in (1.5938 in, 77% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M45 tapped hole drawn to scale: drill 40.5 mm, thread major diameter 45.00 mm25 mm
40.5mm40.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.5945
Millimetres
40.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M45 tap drill sizes from 50% to 85% thread

DrillInchmmThread
42 mm1.653542.0051%
41.5 mm1.633941.5060%
41 mm1.614241.0068%
40.5 mmRecommended1.594540.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M45 bolt

FitDrillInchmm
Close46 mm1.811046.00
Normal48 mm1.889848.00
Loose52 mm2.047252.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M45 thread dimensions

DimensionInchmm
Major diameter (basic)1.771745.00
Pitch diameter (basic)1.656642.08
Minor diameter, internal (basic)1.579940.13
Pitch0.17724.50

Metric coarse (ISO), 4.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

What you'll need

M45 x 4.5 tapPlug tap for through holes, bottoming tap for blind holes
40.5 mm drill bit1.5945 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M45 tap? Use a 40.5 mm drill for an M45 x 4.5 tap (77% thread). The closest inch drill is 1-19/32 (1.5938 in, 77% thread).
M45 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M45 tap?

40.50 mm (1.5945 in). That is the major diameter minus the pitch (45 − 4.5 mm) and gives about 77% thread.

Can I use an inch drill for an M45 tap?

Yes: 1-19/32 in drill (1.5938 in, 40.48 mm) gives about 77% thread.

What is the clearance hole for an M45 bolt?

ISO 273: close fit 46.00 mm, normal fit 48.00 mm, loose fit 52.00 mm.

What does M45 x 4.5 mean?

A 45 mm nominal diameter ISO metric thread with a 4.5 mm pitch (coarse series).