What size drill for an M14 tap?

Short answer: 12 mm drill (0.4724 in, 12.00 mm). That is D − P (14 − 2 mm) and gives about 77% thread. Closest inch drill: 15/32 in (0.4688 in, 81% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M14 tapped hole drawn to scale: drill 12 mm, thread major diameter 14.00 mm10 mm
12mm12 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.4724
Millimetres
12.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M14 tap drill sizes from 50% to 85% thread

DrillInchmmThread
12.7 mm0.500012.7050%
12.6 mm0.496112.6054%
12.5 mm0.492112.5058%
12.4 mm0.488212.4062%
12.3 mm0.484312.3065%
12.2 mm0.480312.2069%
12.1 mm0.476412.1073%
12 mmRecommended0.472412.0077%
11.9 mm0.468511.9081%
11.8 mm0.464611.8085%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M14 bolt

FitDrillInchmm
Close15 mm0.590615.00
Normal15.5 mm0.610215.50
Loose16.5 mm0.649616.50

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M14 thread dimensions

DimensionInchmm
Major diameter (basic)0.551214.00
Pitch diameter (basic)0.500012.70
Minor diameter, internal (basic)0.465911.83
Pitch0.07872.00

Metric coarse (ISO), 2 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M14 x 2 tapPlug tap for through holes, bottoming tap for blind holes
12 mm drill bit0.4724 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M14 tap? Use a 12 mm drill for an M14 x 2 tap (77% thread). The closest inch drill is 15/32 (0.4688 in, 81% thread).
M14 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M14 tap?

12.00 mm (0.4724 in). That is the major diameter minus the pitch (14 − 2 mm) and gives about 77% thread.

Can I use an inch drill for an M14 tap?

Yes: 15/32 in drill (0.4688 in, 11.91 mm) gives about 81% thread.

What is the clearance hole for an M14 bolt?

ISO 273: close fit 15.00 mm, normal fit 15.50 mm, loose fit 16.50 mm.

What does M14 x 2 mean?

A 14 mm nominal diameter ISO metric thread with a 2 mm pitch (coarse series).