What size drill for an M10 tap?

Short answer: 8.5 mm drill (0.3346 in, 8.50 mm). That is D − P (10 − 1.5 mm) and gives about 77% thread. Closest inch drill: Q (0.3320 in, 80% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M10 tapped hole drawn to scale: drill 8.5 mm, thread major diameter 10.00 mm5 mm
8.5mm8.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.3346
Millimetres
8.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M10 tap drill sizes from 50% to 85% thread

DrillInchmmThread
9 mm0.35439.0051%
8.9 mm0.35048.9056%
8.8 mm0.34658.8062%
8.7 mm0.34258.7067%
8.6 mm0.33868.6072%
8.5 mmRecommended0.33468.5077%
8.4 mm0.33078.4082%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M10 bolt

FitDrillInchmm
Close10.5 mm0.413410.50
Normal11 mm0.433111.00
Loose12 mm0.472412.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M10 thread dimensions

DimensionInchmm
Major diameter (basic)0.393710.00
Pitch diameter (basic)0.35539.03
Minor diameter, internal (basic)0.32988.38
Pitch0.05911.50

Metric coarse (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M10 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
8.5 mm drill bit0.3346 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M10 tap? Use an 8.5 mm drill for an M10 x 1.5 tap (77% thread). The closest inch drill is Q (0.3320 in, 80% thread).
M10 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M10 tap?

8.50 mm (0.3346 in). That is the major diameter minus the pitch (10 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M10 tap?

Yes: letter Q drill (0.3320 in, 8.43 mm) gives about 80% thread.

What is the clearance hole for an M10 bolt?

ISO 273: close fit 10.50 mm, normal fit 11.00 mm, loose fit 12.00 mm.

What does M10 x 1.5 mean?

A 10 mm nominal diameter ISO metric thread with a 1.5 mm pitch (coarse series).