What size drill for an M36 tap?

Short answer: 32 mm drill (1.2598 in, 32.00 mm). That is D − P (36 − 4 mm) and gives about 77% thread. Closest inch drill: 1-17/64 in (1.2656 in, 74% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M36 tapped hole drawn to scale: drill 32 mm, thread major diameter 36.00 mm25 mm
32mm32 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.2598
Millimetres
32.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M36 tap drill sizes from 50% to 85% thread

DrillInchmmThread
33 mm1.299233.0058%
32.5 mm1.279532.5067%
32 mmRecommended1.259832.0077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M36 bolt

FitDrillInchmm
Close37 mm1.456737.00
Normal39 mm1.535439.00
Loose42 mm1.653542.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M36 thread dimensions

DimensionInchmm
Major diameter (basic)1.417336.00
Pitch diameter (basic)1.315033.40
Minor diameter, internal (basic)1.246831.67
Pitch0.15754.00

Metric coarse (ISO), 4 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M36 x 4 tapPlug tap for through holes, bottoming tap for blind holes
32 mm drill bit1.2598 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M36 tap? Use a 32 mm drill for an M36 x 4 tap (77% thread). The closest inch drill is 1-17/64 (1.2656 in, 74% thread).
M36 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M36 tap?

32.00 mm (1.2598 in). That is the major diameter minus the pitch (36 − 4 mm) and gives about 77% thread.

Can I use an inch drill for an M36 tap?

Yes: 1-17/64 in drill (1.2656 in, 32.15 mm) gives about 74% thread.

What is the clearance hole for an M36 bolt?

ISO 273: close fit 37.00 mm, normal fit 39.00 mm, loose fit 42.00 mm.

What does M36 x 4 mean?

A 36 mm nominal diameter ISO metric thread with a 4 mm pitch (coarse series).