What size drill for an M3.5 tap?
Short answer: 2.9 mm drill (0.1142 in, 2.90 mm). That is D − P (3.5 − 0.6 mm) and gives about 77% thread. Closest inch drill: #33 (0.1130 in, 81% thread).
Your tap
75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).
M3.5 tap drill sizes from 50% to 85% thread
| Drill | Inch | mm | Thread |
|---|---|---|---|
| 3.1 mm | 0.1220 | 3.10 | 51% |
| 3 mm | 0.1181 | 3.00 | 64% |
| 2.95 mm | 0.1161 | 2.95 | 71% |
| 2.9 mmRecommended | 0.1142 | 2.90 | 77% |
| 2.85 mm | 0.1122 | 2.85 | 83% |
Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate
Clearance hole for an M3.5 bolt
| Fit | Drill | Inch | mm |
|---|---|---|---|
| Close | 3.7 mm | 0.1457 | 3.70 |
| Normal | 3.9 mm | 0.1535 | 3.90 |
| Loose | 4.2 mm | 0.1654 | 4.20 |
ISO 273: fine (close), medium (normal) and coarse (loose) series.
M3.5 thread dimensions
| Dimension | Inch | mm |
|---|---|---|
| Major diameter (basic) | 0.1378 | 3.50 |
| Pitch diameter (basic) | 0.1225 | 3.11 |
| Minor diameter, internal (basic) | 0.1122 | 2.85 |
| Pitch | 0.0236 | 0.60 |
Metric coarse (ISO), 0.6 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.
What you'll need
Other metric tap drill sizes

Questions
What size drill bit for an M3.5 tap?
2.90 mm (0.1142 in). That is the major diameter minus the pitch (3.5 − 0.6 mm) and gives about 77% thread.
Can I use an inch drill for an M3.5 tap?
Yes: #33 drill (0.1130 in, 2.87 mm) gives about 81% thread.
What is the clearance hole for an M3.5 bolt?
ISO 273: close fit 3.70 mm, normal fit 3.90 mm, loose fit 4.20 mm.
What does M3.5 x 0.6 mean?
A 3.5 mm nominal diameter ISO metric thread with a 0.6 mm pitch (coarse series).
https://whatsizeis.com/tap-drill/m3-5/