What size drill for an M39 tap?

Short answer: 35 mm drill (1.3780 in, 35.00 mm). That is D − P (39 − 4 mm) and gives about 77% thread. Closest inch drill: 1-3/8 in (1.3750 in, 78% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M39 tapped hole drawn to scale: drill 35 mm, thread major diameter 39.00 mm25 mm
35mm35 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.3780
Millimetres
35.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M39 tap drill sizes from 50% to 85% thread

DrillInchmmThread
36 mm1.417336.0058%
35.5 mm1.397635.5067%
35 mmRecommended1.378035.0077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M39 bolt

FitDrillInchmm
Close40 mm1.574840.00
Normal42 mm1.653542.00
Loose45 mm1.771745.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M39 thread dimensions

DimensionInchmm
Major diameter (basic)1.535439.00
Pitch diameter (basic)1.433136.40
Minor diameter, internal (basic)1.365034.67
Pitch0.15754.00

Metric coarse (ISO), 4 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

What you'll need

M39 x 4 tapPlug tap for through holes, bottoming tap for blind holes
35 mm drill bit1.3780 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M39 tap? Use a 35 mm drill for an M39 x 4 tap (77% thread). The closest inch drill is 1-3/8 (1.3750 in, 78% thread).
M39 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M39 tap?

35.00 mm (1.3780 in). That is the major diameter minus the pitch (39 − 4 mm) and gives about 77% thread.

Can I use an inch drill for an M39 tap?

Yes: 1-3/8 in drill (1.3750 in, 34.93 mm) gives about 78% thread.

What is the clearance hole for an M39 bolt?

ISO 273: close fit 40.00 mm, normal fit 42.00 mm, loose fit 45.00 mm.

What does M39 x 4 mean?

A 39 mm nominal diameter ISO metric thread with a 4 mm pitch (coarse series).