What size drill for an M12 tap?

Short answer: 10.2 mm drill (0.4016 in, 10.20 mm). That is D − P (12 − 1.75 mm) and gives about 79% thread. Closest inch drill: Y (0.4040 in, 76% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M12 tapped hole drawn to scale: drill 10.2 mm, thread major diameter 12.00 mm5 mm
10.2mm10.2 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.4016
Millimetres
10.20
Thread
79%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M12 tap drill sizes from 50% to 85% thread

DrillInchmmThread
10.8 mm0.425210.8053%
10.7 mm0.421310.7057%
10.6 mm0.417310.6062%
10.5 mm0.413410.5066%
10.4 mm0.409410.4070%
10.3 mm0.405510.3075%
10.2 mmRecommended0.401610.2079%
10.1 mm0.397610.1084%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M12 bolt

FitDrillInchmm
Close13 mm0.511813.00
Normal13.5 mm0.531513.50
Loose14.5 mm0.570914.50

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M12 thread dimensions

DimensionInchmm
Major diameter (basic)0.472412.00
Pitch diameter (basic)0.427710.86
Minor diameter, internal (basic)0.397910.11
Pitch0.06891.75

Metric coarse (ISO), 1.75 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M12 x 1.75 tapPlug tap for through holes, bottoming tap for blind holes
10.2 mm drill bit0.4016 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M12 tap? Use a 10.2 mm drill for an M12 x 1.75 tap (79% thread). The closest inch drill is Y (0.4040 in, 76% thread).
M12 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M12 tap?

10.20 mm (0.4016 in). That is the major diameter minus the pitch (12 − 1.75 mm) and gives about 79% thread.

Can I use an inch drill for an M12 tap?

Yes: letter Y drill (0.4040 in, 10.26 mm) gives about 76% thread.

What is the clearance hole for an M12 bolt?

ISO 273: close fit 13.00 mm, normal fit 13.50 mm, loose fit 14.50 mm.

What does M12 x 1.75 mean?

A 12 mm nominal diameter ISO metric thread with a 1.75 mm pitch (coarse series).