What size drill for an M6 tap?

Short answer: 5 mm drill (0.1969 in, 5.00 mm). That is D − P (6 − 1 mm) and gives about 77% thread. Closest inch drill: #9 (0.1960 in, 79% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M6 tapped hole drawn to scale: drill 5 mm, thread major diameter 6.00 mm2 mm
5mm5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.1969
Millimetres
5.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M6 tap drill sizes from 50% to 85% thread

DrillInchmmThread
5.3 mm0.20875.3054%
5.2 mm0.20475.2062%
5.1 mm0.20085.1069%
5 mmRecommended0.19695.0077%
4.9 mm0.19294.9085%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M6 bolt

FitDrillInchmm
Close6.4 mm0.25206.40
Normal6.6 mm0.25986.60
Loose7 mm0.27567.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M6 thread dimensions

DimensionInchmm
Major diameter (basic)0.23626.00
Pitch diameter (basic)0.21065.35
Minor diameter, internal (basic)0.19364.92
Pitch0.03941.00

Metric coarse (ISO), 1 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

What you'll need

M6 x 1 tapPlug tap for through holes, bottoming tap for blind holes
5 mm drill bit0.1969 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M6 tap? Use a 5 mm drill for an M6 x 1 tap (77% thread). The closest inch drill is #9 (0.1960 in, 79% thread).
M6 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M6 tap?

5.00 mm (0.1969 in). That is the major diameter minus the pitch (6 − 1 mm) and gives about 77% thread.

Can I use an inch drill for an M6 tap?

Yes: #9 drill (0.1960 in, 4.98 mm) gives about 79% thread.

What is the clearance hole for an M6 bolt?

ISO 273: close fit 6.40 mm, normal fit 6.60 mm, loose fit 7.00 mm.

What does M6 x 1 mean?

A 6 mm nominal diameter ISO metric thread with a 1 mm pitch (coarse series).