What size drill for an M33 tap?

Short answer: 29.5 mm drill (1.1614 in, 29.50 mm). That is D − P (33 − 3.5 mm) and gives about 77% thread. Closest inch drill: 1-5/32 in (1.1563 in, 80% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M33 tapped hole drawn to scale: drill 29.5 mm, thread major diameter 33.00 mm25 mm
29.5mm29.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.1614
Millimetres
29.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M33 tap drill sizes from 50% to 85% thread

DrillInchmmThread
30.5 mm1.200830.5055%
30 mm1.181130.0066%
29.5 mmRecommended1.161429.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M33 bolt

FitDrillInchmm
Close34 mm1.338634.00
Normal36 mm1.417336.00
Loose38 mm1.496138.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M33 thread dimensions

DimensionInchmm
Major diameter (basic)1.299233.00
Pitch diameter (basic)1.209730.73
Minor diameter, internal (basic)1.150029.21
Pitch0.13783.50

Metric coarse (ISO), 3.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M33 x 3.5 tapPlug tap for through holes, bottoming tap for blind holes
29.5 mm drill bit1.1614 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M33 tap? Use a 29.5 mm drill for an M33 x 3.5 tap (77% thread). The closest inch drill is 1-5/32 (1.1563 in, 80% thread).
M33 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M33 tap?

29.50 mm (1.1614 in). That is the major diameter minus the pitch (33 − 3.5 mm) and gives about 77% thread.

Can I use an inch drill for an M33 tap?

Yes: 1-5/32 in drill (1.1563 in, 29.37 mm) gives about 80% thread.

What is the clearance hole for an M33 bolt?

ISO 273: close fit 34.00 mm, normal fit 36.00 mm, loose fit 38.00 mm.

What does M33 x 3.5 mean?

A 33 mm nominal diameter ISO metric thread with a 3.5 mm pitch (coarse series).