What size drill for an M42 tap?

Short answer: 37.5 mm drill (1.4764 in, 37.50 mm). That is D − P (42 − 4.5 mm) and gives about 77% thread. Closest inch drill: 1-15/32 in (1.4688 in, 80% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M42 tapped hole drawn to scale: drill 37.5 mm, thread major diameter 42.00 mm25 mm
37.5mm37.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.4764
Millimetres
37.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M42 tap drill sizes from 50% to 85% thread

DrillInchmmThread
39 mm1.535439.0051%
38.5 mm1.515738.5060%
38 mm1.496138.0068%
37.5 mmRecommended1.476437.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M42 bolt

FitDrillInchmm
Close43 mm1.692943.00
Normal45 mm1.771745.00
Loose48 mm1.889848.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M42 thread dimensions

DimensionInchmm
Major diameter (basic)1.653542.00
Pitch diameter (basic)1.538539.08
Minor diameter, internal (basic)1.461837.13
Pitch0.17724.50

Metric coarse (ISO), 4.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

What you'll need

M42 x 4.5 tapPlug tap for through holes, bottoming tap for blind holes
37.5 mm drill bit1.4764 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M42 tap? Use a 37.5 mm drill for an M42 x 4.5 tap (77% thread). The closest inch drill is 1-15/32 (1.4688 in, 80% thread).
M42 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M42 tap?

37.50 mm (1.4764 in). That is the major diameter minus the pitch (42 − 4.5 mm) and gives about 77% thread.

Can I use an inch drill for an M42 tap?

Yes: 1-15/32 in drill (1.4688 in, 37.31 mm) gives about 80% thread.

What is the clearance hole for an M42 bolt?

ISO 273: close fit 43.00 mm, normal fit 45.00 mm, loose fit 48.00 mm.

What does M42 x 4.5 mean?

A 42 mm nominal diameter ISO metric thread with a 4.5 mm pitch (coarse series).