What size drill for an M30x1 tap?

Short answer: 29 mm drill (1.1417 in, 29.00 mm). That is D − P (30 − 1 mm) and gives about 77% thread. Closest inch drill: 1-9/64 in (1.1406 in, 79% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M30x1 tapped hole drawn to scale: drill 29 mm, thread major diameter 30.00 mm20 mm
29mm29 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.1417
Millimetres
29.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M30x1 tap drill sizes from 50% to 85% thread

DrillInchmmThread
29 mmRecommended1.141729.0077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M30 bolt

FitDrillInchmm
Close31 mm1.220531.00
Normal33 mm1.299233.00
Loose35 mm1.378035.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M30x1 thread dimensions

DimensionInchmm
Major diameter (basic)1.181130.00
Pitch diameter (basic)1.155529.35
Minor diameter, internal (basic)1.138528.92
Pitch0.03941.00

Metric fine (ISO), 1 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M30 x 1 tapPlug tap for through holes, bottoming tap for blind holes
29 mm drill bit1.1417 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M30x1 tap? Use a 29 mm drill for an M30 x 1 tap (77% thread). The closest inch drill is 1-9/64 (1.1406 in, 79% thread).
M30x1 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M30x1 tap?

29.00 mm (1.1417 in). That is the major diameter minus the pitch (30 − 1 mm) and gives about 77% thread.

Can I use an inch drill for an M30x1 tap?

Yes: 1-9/64 in drill (1.1406 in, 28.97 mm) gives about 79% thread.

What is the clearance hole for an M30 bolt?

ISO 273: close fit 31.00 mm, normal fit 33.00 mm, loose fit 35.00 mm.

What does M30 x 1 mean?

A 30 mm nominal diameter ISO metric thread with a 1 mm pitch (fine series).