What size drill for an M1 tap?

Short answer: 0.75 mm drill (0.0295 in, 0.75 mm). That is D − P (1 − 0.25 mm) and gives about 77% thread. Closest inch drill: #69 (0.0292 in, 80% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M1 tapped hole drawn to scale: drill 0.75 mm, thread major diameter 1.00 mm0.5 mm
0.75mm0.75 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.0295
Millimetres
0.75
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M1 tap drill sizes from 50% to 85% thread

DrillInchmmThread
0.8 mm0.03150.8062%
0.75 mmRecommended0.02950.7577%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M1 bolt

FitDrillInchmm
Close1.1 mm0.04331.10
Normal1.2 mm0.04721.20
Loose1.3 mm0.05121.30

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M1 thread dimensions

DimensionInchmm
Major diameter (basic)0.03941.00
Pitch diameter (basic)0.03300.84
Minor diameter, internal (basic)0.02870.73
Pitch0.00980.25

Metric coarse (ISO), 0.25 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

What you'll need

M1 x 0.25 tapPlug tap for through holes, bottoming tap for blind holes
0.75 mm drill bit0.0295 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M1 tap? Use a 0.75 mm drill for an M1 x 0.25 tap (77% thread). The closest inch drill is #69 (0.0292 in, 80% thread).
M1 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M1 tap?

0.75 mm (0.0295 in). That is the major diameter minus the pitch (1 − 0.25 mm) and gives about 77% thread.

Can I use an inch drill for an M1 tap?

Yes: #69 drill (0.0292 in, 0.74 mm) gives about 80% thread.

What is the clearance hole for an M1 bolt?

ISO 273: close fit 1.10 mm, normal fit 1.20 mm, loose fit 1.30 mm.

What does M1 x 0.25 mean?

A 1 mm nominal diameter ISO metric thread with a 0.25 mm pitch (coarse series).