What size drill for an M48 tap?

Short answer: 43 mm drill (1.6929 in, 43.00 mm). That is D − P (48 − 5 mm) and gives about 77% thread. Closest inch drill: 1-11/16 in (1.6875 in, 79% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M48 tapped hole drawn to scale: drill 43 mm, thread major diameter 48.00 mm25 mm
43mm43 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.6929
Millimetres
43.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M48 tap drill sizes from 50% to 85% thread

DrillInchmmThread
44.5 mm1.752044.5054%
44 mm1.732344.0062%
43.5 mm1.712643.5069%
43 mmRecommended1.692943.0077%
42.5 mm1.673242.5085%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M48 bolt

FitDrillInchmm
Close50 mm1.968550.00
Normal52 mm2.047252.00
Loose56 mm2.204756.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M48 thread dimensions

DimensionInchmm
Major diameter (basic)1.889848.00
Pitch diameter (basic)1.761944.75
Minor diameter, internal (basic)1.676742.59
Pitch0.19695.00

Metric coarse (ISO), 5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

What you'll need

M48 x 5 tapPlug tap for through holes, bottoming tap for blind holes
43 mm drill bit1.6929 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M48 tap? Use a 43 mm drill for an M48 x 5 tap (77% thread). The closest inch drill is 1-11/16 (1.6875 in, 79% thread).
M48 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M48 tap?

43.00 mm (1.6929 in). That is the major diameter minus the pitch (48 − 5 mm) and gives about 77% thread.

Can I use an inch drill for an M48 tap?

Yes: 1-11/16 in drill (1.6875 in, 42.86 mm) gives about 79% thread.

What is the clearance hole for an M48 bolt?

ISO 273: close fit 50.00 mm, normal fit 52.00 mm, loose fit 56.00 mm.

What does M48 x 5 mean?

A 48 mm nominal diameter ISO metric thread with a 5 mm pitch (coarse series).