What size drill for an M33x2 tap?

Short answer: 31 mm drill (1.2205 in, 31.00 mm). That is D − P (33 − 2 mm) and gives about 77% thread. Closest inch drill: 1-7/32 in (1.2188 in, 79% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M33x2 tapped hole drawn to scale: drill 31 mm, thread major diameter 33.00 mm25 mm
31mm31 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.2205
Millimetres
31.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M33x2 tap drill sizes from 50% to 85% thread

DrillInchmmThread
31.5 mm1.240231.5058%
31 mmRecommended1.220531.0077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M33 bolt

FitDrillInchmm
Close34 mm1.338634.00
Normal36 mm1.417336.00
Loose38 mm1.496138.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M33x2 thread dimensions

DimensionInchmm
Major diameter (basic)1.299233.00
Pitch diameter (basic)1.248131.70
Minor diameter, internal (basic)1.214030.83
Pitch0.07872.00

Metric fine (ISO), 2 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M33 x 2 tapPlug tap for through holes, bottoming tap for blind holes
31 mm drill bit1.2205 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M33x2 tap? Use a 31 mm drill for an M33 x 2 tap (77% thread). The closest inch drill is 1-7/32 (1.2188 in, 79% thread).
M33x2 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M33x2 tap?

31.00 mm (1.2205 in). That is the major diameter minus the pitch (33 − 2 mm) and gives about 77% thread.

Can I use an inch drill for an M33x2 tap?

Yes: 1-7/32 in drill (1.2188 in, 30.96 mm) gives about 79% thread.

What is the clearance hole for an M33 bolt?

ISO 273: close fit 34.00 mm, normal fit 36.00 mm, loose fit 38.00 mm.

What does M33 x 2 mean?

A 33 mm nominal diameter ISO metric thread with a 2 mm pitch (fine series).