What size drill for an M14x1.5 tap?

Short answer: 12.5 mm drill (0.4921 in, 12.50 mm). That is D − P (14 − 1.5 mm) and gives about 77% thread. Closest inch drill: 31/64 in (0.4844 in, 87% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M14x1.5 tapped hole drawn to scale: drill 12.5 mm, thread major diameter 14.00 mm10 mm
12.5mm12.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.4921
Millimetres
12.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M14x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
13 mm0.511813.0051%
12.9 mm0.507912.9056%
12.8 mm0.503912.8062%
12.7 mm0.500012.7067%
12.6 mm0.496112.6072%
12.5 mmRecommended0.492112.5077%
12.4 mm0.488212.4082%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M14 bolt

FitDrillInchmm
Close15 mm0.590615.00
Normal15.5 mm0.610215.50
Loose16.5 mm0.649616.50

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M14x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)0.551214.00
Pitch diameter (basic)0.512813.03
Minor diameter, internal (basic)0.487312.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M14 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
12.5 mm drill bit0.4921 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M14x1.5 tap? Use a 12.5 mm drill for an M14 x 1.5 tap (77% thread). The closest inch drill is 31/64 (0.4844 in, 87% thread).
M14x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M14x1.5 tap?

12.50 mm (0.4921 in). That is the major diameter minus the pitch (14 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M14x1.5 tap?

Yes: 31/64 in drill (0.4844 in, 12.30 mm) gives about 87% thread.

What is the clearance hole for an M14 bolt?

ISO 273: close fit 15.00 mm, normal fit 15.50 mm, loose fit 16.50 mm.

What does M14 x 1.5 mean?

A 14 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).