What size drill for an M14x1 tap?

Short answer: 13 mm drill (0.5118 in, 13.00 mm). That is D − P (14 − 1 mm) and gives about 77% thread. Closest inch drill: 33/64 in (0.5156 in, 70% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M14x1 tapped hole drawn to scale: drill 13 mm, thread major diameter 14.00 mm10 mm
13mm13 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.5118
Millimetres
13.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M14x1 tap drill sizes from 50% to 85% thread

DrillInchmmThread
13.3 mm0.523613.3054%
13.2 mm0.519713.2062%
13.1 mm0.515713.1069%
13 mmRecommended0.511813.0077%
12.9 mm0.507912.9085%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M14 bolt

FitDrillInchmm
Close15 mm0.590615.00
Normal15.5 mm0.610215.50
Loose16.5 mm0.649616.50

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M14x1 thread dimensions

DimensionInchmm
Major diameter (basic)0.551214.00
Pitch diameter (basic)0.525613.35
Minor diameter, internal (basic)0.508612.92
Pitch0.03941.00

Metric fine (ISO), 1 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M14 x 1 tapPlug tap for through holes, bottoming tap for blind holes
13 mm drill bit0.5118 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M14x1 tap? Use a 13 mm drill for an M14 x 1 tap (77% thread). The closest inch drill is 33/64 (0.5156 in, 70% thread).
M14x1 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M14x1 tap?

13.00 mm (0.5118 in). That is the major diameter minus the pitch (14 − 1 mm) and gives about 77% thread.

Can I use an inch drill for an M14x1 tap?

Yes: 33/64 in drill (0.5156 in, 13.10 mm) gives about 70% thread.

What is the clearance hole for an M14 bolt?

ISO 273: close fit 15.00 mm, normal fit 15.50 mm, loose fit 16.50 mm.

What does M14 x 1 mean?

A 14 mm nominal diameter ISO metric thread with a 1 mm pitch (fine series).