What size drill for an M10x1 tap?

Short answer: 9 mm drill (0.3543 in, 9.00 mm). That is D − P (10 − 1 mm) and gives about 77% thread. Closest inch drill: T (0.3580 in, 70% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M10x1 tapped hole drawn to scale: drill 9 mm, thread major diameter 10.00 mm5 mm
9mm9 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.3543
Millimetres
9.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M10x1 tap drill sizes from 50% to 85% thread

DrillInchmmThread
9.3 mm0.36619.3054%
9.2 mm0.36229.2062%
9.1 mm0.35839.1069%
9 mmRecommended0.35439.0077%
8.9 mm0.35048.9085%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M10 bolt

FitDrillInchmm
Close10.5 mm0.413410.50
Normal11 mm0.433111.00
Loose12 mm0.472412.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M10x1 thread dimensions

DimensionInchmm
Major diameter (basic)0.393710.00
Pitch diameter (basic)0.36819.35
Minor diameter, internal (basic)0.35118.92
Pitch0.03941.00

Metric fine (ISO), 1 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M10 x 1 tapPlug tap for through holes, bottoming tap for blind holes
9 mm drill bit0.3543 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M10x1 tap? Use a 9 mm drill for an M10 x 1 tap (77% thread). The closest inch drill is T (0.3580 in, 70% thread).
M10x1 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M10x1 tap?

9.00 mm (0.3543 in). That is the major diameter minus the pitch (10 − 1 mm) and gives about 77% thread.

Can I use an inch drill for an M10x1 tap?

Yes: letter T drill (0.3580 in, 9.09 mm) gives about 70% thread.

What is the clearance hole for an M10 bolt?

ISO 273: close fit 10.50 mm, normal fit 11.00 mm, loose fit 12.00 mm.

What does M10 x 1 mean?

A 10 mm nominal diameter ISO metric thread with a 1 mm pitch (fine series).