What size drill for an M36x1.5 tap?

Short answer: 34.5 mm drill (1.3583 in, 34.50 mm). That is D − P (36 − 1.5 mm) and gives about 77% thread. Closest inch drill: 1-23/64 in (1.3594 in, 76% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M36x1.5 tapped hole drawn to scale: drill 34.5 mm, thread major diameter 36.00 mm25 mm
34.5mm34.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.3583
Millimetres
34.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M36x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
35 mm1.378035.0051%
34.5 mmRecommended1.358334.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M36 bolt

FitDrillInchmm
Close37 mm1.456737.00
Normal39 mm1.535439.00
Loose42 mm1.653542.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M36x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)1.417336.00
Pitch diameter (basic)1.379035.03
Minor diameter, internal (basic)1.353434.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M36 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
34.5 mm drill bit1.3583 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M36x1.5 tap? Use a 34.5 mm drill for an M36 x 1.5 tap (77% thread). The closest inch drill is 1-23/64 (1.3594 in, 76% thread).
M36x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M36x1.5 tap?

34.50 mm (1.3583 in). That is the major diameter minus the pitch (36 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M36x1.5 tap?

Yes: 1-23/64 in drill (1.3594 in, 34.53 mm) gives about 76% thread.

What is the clearance hole for an M36 bolt?

ISO 273: close fit 37.00 mm, normal fit 39.00 mm, loose fit 42.00 mm.

What does M36 x 1.5 mean?

A 36 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).