What size drill for an M27x1.5 tap?

Short answer: 25.5 mm drill (1.0039 in, 25.50 mm). That is D − P (27 − 1.5 mm) and gives about 77% thread. Closest inch drill: 1 in (1.0000 in, 82% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M27x1.5 tapped hole drawn to scale: drill 25.5 mm, thread major diameter 27.00 mm20 mm
25.5mm25.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.0039
Millimetres
25.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M27x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
26 mm1.023626.0051%
25.5 mmRecommended1.003925.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M27 bolt

FitDrillInchmm
Close28 mm1.102428.00
Normal30 mm1.181130.00
Loose32 mm1.259832.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M27x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)1.063027.00
Pitch diameter (basic)1.024626.03
Minor diameter, internal (basic)0.999125.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M27 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
25.5 mm drill bit1.0039 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M27x1.5 tap? Use a 25.5 mm drill for an M27 x 1.5 tap (77% thread). The closest inch drill is 1 (1.0000 in, 82% thread).
M27x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M27x1.5 tap?

25.50 mm (1.0039 in). That is the major diameter minus the pitch (27 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M27x1.5 tap?

Yes: 1 in drill (1.0000 in, 25.40 mm) gives about 82% thread.

What is the clearance hole for an M27 bolt?

ISO 273: close fit 28.00 mm, normal fit 30.00 mm, loose fit 32.00 mm.

What does M27 x 1.5 mean?

A 27 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).