What size drill for an M24x1.5 tap?

Short answer: 22.5 mm drill (0.8858 in, 22.50 mm). That is D − P (24 − 1.5 mm) and gives about 77% thread. Closest inch drill: 57/64 in (0.8906 in, 71% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M24x1.5 tapped hole drawn to scale: drill 22.5 mm, thread major diameter 24.00 mm10 mm
22.5mm22.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.8858
Millimetres
22.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M24x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
23 mm0.905523.0051%
22.5 mmRecommended0.885822.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M24 bolt

FitDrillInchmm
Close25 mm0.984325.00
Normal26 mm1.023626.00
Loose28 mm1.102428.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M24x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)0.944924.00
Pitch diameter (basic)0.906523.03
Minor diameter, internal (basic)0.881022.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M24 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
22.5 mm drill bit0.8858 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M24x1.5 tap? Use a 22.5 mm drill for an M24 x 1.5 tap (77% thread). The closest inch drill is 57/64 (0.8906 in, 71% thread).
M24x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M24x1.5 tap?

22.50 mm (0.8858 in). That is the major diameter minus the pitch (24 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M24x1.5 tap?

Yes: 57/64 in drill (0.8906 in, 22.62 mm) gives about 71% thread.

What is the clearance hole for an M24 bolt?

ISO 273: close fit 25.00 mm, normal fit 26.00 mm, loose fit 28.00 mm.

What does M24 x 1.5 mean?

A 24 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).