What size drill for an M18x1.5 tap?

Short answer: 16.5 mm drill (0.6496 in, 16.50 mm). That is D − P (18 − 1.5 mm) and gives about 77% thread. Closest inch drill: 21/32 in (0.6563 in, 68% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M18x1.5 tapped hole drawn to scale: drill 16.5 mm, thread major diameter 18.00 mm10 mm
16.5mm16.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.6496
Millimetres
16.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M18x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
17 mm0.669317.0051%
16.5 mmRecommended0.649616.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M18 bolt

FitDrillInchmm
Close19 mm0.748019.00
Normal20 mm0.787420.00
Loose21 mm0.826821.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M18x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)0.708718.00
Pitch diameter (basic)0.670317.03
Minor diameter, internal (basic)0.644716.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M18 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
16.5 mm drill bit0.6496 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M18x1.5 tap? Use a 16.5 mm drill for an M18 x 1.5 tap (77% thread). The closest inch drill is 21/32 (0.6563 in, 68% thread).
M18x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M18x1.5 tap?

16.50 mm (0.6496 in). That is the major diameter minus the pitch (18 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M18x1.5 tap?

Yes: 21/32 in drill (0.6563 in, 16.67 mm) gives about 68% thread.

What is the clearance hole for an M18 bolt?

ISO 273: close fit 19.00 mm, normal fit 20.00 mm, loose fit 21.00 mm.

What does M18 x 1.5 mean?

An 18 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).