What size drill for an M4x0.5 tap?

Short answer: 3.5 mm drill (0.1378 in, 3.50 mm). That is D − P (4 − 0.5 mm) and gives about 77% thread. Closest inch drill: #29 (0.1360 in, 84% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M4x0.5 tapped hole drawn to scale: drill 3.5 mm, thread major diameter 4.00 mm2 mm
3.5mm3.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.1378
Millimetres
3.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M4x0.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
3.6 mm0.14173.6062%
3.5 mmRecommended0.13783.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M4 bolt

FitDrillInchmm
Close4.3 mm0.16934.30
Normal4.5 mm0.17724.50
Loose4.8 mm0.18904.80

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M4x0.5 thread dimensions

DimensionInchmm
Major diameter (basic)0.15754.00
Pitch diameter (basic)0.14473.68
Minor diameter, internal (basic)0.13623.46
Pitch0.01970.50

Metric fine (ISO), 0.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M4 x 0.5 tapPlug tap for through holes, bottoming tap for blind holes
3.5 mm drill bit0.1378 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M4x0.5 tap? Use a 3.5 mm drill for an M4 x 0.5 tap (77% thread). The closest inch drill is #29 (0.1360 in, 84% thread).
M4x0.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M4x0.5 tap?

3.50 mm (0.1378 in). That is the major diameter minus the pitch (4 − 0.5 mm) and gives about 77% thread.

Can I use an inch drill for an M4x0.5 tap?

Yes: #29 drill (0.1360 in, 3.45 mm) gives about 84% thread.

What is the clearance hole for an M4 bolt?

ISO 273: close fit 4.30 mm, normal fit 4.50 mm, loose fit 4.80 mm.

What does M4 x 0.5 mean?

A 4 mm nominal diameter ISO metric thread with a 0.5 mm pitch (fine series).