What size drill for an M20x1.5 tap?

Short answer: 18.5 mm drill (0.7283 in, 18.50 mm). That is D − P (20 − 1.5 mm) and gives about 77% thread. Closest inch drill: 47/64 in (0.7344 in, 69% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M20x1.5 tapped hole drawn to scale: drill 18.5 mm, thread major diameter 20.00 mm10 mm
18.5mm18.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.7283
Millimetres
18.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M20x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
19 mm0.748019.0051%
18.5 mmRecommended0.728318.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M20 bolt

FitDrillInchmm
Close21 mm0.826821.00
Normal22 mm0.866122.00
Loose24 mm0.944924.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M20x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)0.787420.00
Pitch diameter (basic)0.749019.03
Minor diameter, internal (basic)0.723518.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M20 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
18.5 mm drill bit0.7283 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M20x1.5 tap? Use an 18.5 mm drill for an M20 x 1.5 tap (77% thread). The closest inch drill is 47/64 (0.7344 in, 69% thread).
M20x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M20x1.5 tap?

18.50 mm (0.7283 in). That is the major diameter minus the pitch (20 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M20x1.5 tap?

Yes: 47/64 in drill (0.7344 in, 18.65 mm) gives about 69% thread.

What is the clearance hole for an M20 bolt?

ISO 273: close fit 21.00 mm, normal fit 22.00 mm, loose fit 24.00 mm.

What does M20 x 1.5 mean?

A 20 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).