What size drill for an M24x2 tap?

Short answer: 22 mm drill (0.8661 in, 22.00 mm). That is D − P (24 − 2 mm) and gives about 77% thread. Closest inch drill: 55/64 in (0.8594 in, 84% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M24x2 tapped hole drawn to scale: drill 22 mm, thread major diameter 24.00 mm10 mm
22mm22 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.8661
Millimetres
22.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M24x2 tap drill sizes from 50% to 85% thread

DrillInchmmThread
22.5 mm0.885822.5058%
22 mmRecommended0.866122.0077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M24 bolt

FitDrillInchmm
Close25 mm0.984325.00
Normal26 mm1.023626.00
Loose28 mm1.102428.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M24x2 thread dimensions

DimensionInchmm
Major diameter (basic)0.944924.00
Pitch diameter (basic)0.893722.70
Minor diameter, internal (basic)0.859621.83
Pitch0.07872.00

Metric fine (ISO), 2 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M24 x 2 tapPlug tap for through holes, bottoming tap for blind holes
22 mm drill bit0.8661 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M24x2 tap? Use a 22 mm drill for an M24 x 2 tap (77% thread). The closest inch drill is 55/64 (0.8594 in, 84% thread).
M24x2 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M24x2 tap?

22.00 mm (0.8661 in). That is the major diameter minus the pitch (24 − 2 mm) and gives about 77% thread.

Can I use an inch drill for an M24x2 tap?

Yes: 55/64 in drill (0.8594 in, 21.83 mm) gives about 84% thread.

What is the clearance hole for an M24 bolt?

ISO 273: close fit 25.00 mm, normal fit 26.00 mm, loose fit 28.00 mm.

What does M24 x 2 mean?

A 24 mm nominal diameter ISO metric thread with a 2 mm pitch (fine series).