What size drill for an M16x1.5 tap?

Short answer: 14.5 mm drill (0.5709 in, 14.50 mm). That is D − P (16 − 1.5 mm) and gives about 77% thread. Closest inch drill: 37/64 in (0.5781 in, 68% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M16x1.5 tapped hole drawn to scale: drill 14.5 mm, thread major diameter 16.00 mm10 mm
14.5mm14.5 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.5709
Millimetres
14.50
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M16x1.5 tap drill sizes from 50% to 85% thread

DrillInchmmThread
15 mm0.590615.0051%
14.5 mmRecommended0.570914.5077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M16 bolt

FitDrillInchmm
Close17 mm0.669317.00
Normal17.5 mm0.689017.50
Loose18.5 mm0.728318.50

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M16x1.5 thread dimensions

DimensionInchmm
Major diameter (basic)0.629916.00
Pitch diameter (basic)0.591615.03
Minor diameter, internal (basic)0.566014.38
Pitch0.05911.50

Metric fine (ISO), 1.5 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M16 x 1.5 tapPlug tap for through holes, bottoming tap for blind holes
14.5 mm drill bit0.5709 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M16x1.5 tap? Use a 14.5 mm drill for an M16 x 1.5 tap (77% thread). The closest inch drill is 37/64 (0.5781 in, 68% thread).
M16x1.5 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M16x1.5 tap?

14.50 mm (0.5709 in). That is the major diameter minus the pitch (16 − 1.5 mm) and gives about 77% thread.

Can I use an inch drill for an M16x1.5 tap?

Yes: 37/64 in drill (0.5781 in, 14.68 mm) gives about 68% thread.

What is the clearance hole for an M16 bolt?

ISO 273: close fit 17.00 mm, normal fit 17.50 mm, loose fit 18.50 mm.

What does M16 x 1.5 mean?

A 16 mm nominal diameter ISO metric thread with a 1.5 mm pitch (fine series).