What size drill for an M18x1 tap?

Short answer: 17 mm drill (0.6693 in, 17.00 mm). That is D − P (18 − 1 mm) and gives about 77% thread. Closest inch drill: 43/64 in (0.6719 in, 72% thread).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
M18x1 tapped hole drawn to scale: drill 17 mm, thread major diameter 18.00 mm10 mm
17mm17 mm drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.6693
Millimetres
17.00
Thread
77%
Download PDF chartShared link keeps your settings: 75% thread, metric drills

M18x1 tap drill sizes from 50% to 85% thread

DrillInchmmThread
17 mmRecommended0.669317.0077%

Recommended: major diameter minus pitch (ISO 2306 practice). Percent of thread uses the 1.299 × pitch convention of US charts. How we calculate

Clearance hole for an M18 bolt

FitDrillInchmm
Close19 mm0.748019.00
Normal20 mm0.787420.00
Loose21 mm0.826821.00

ISO 273: fine (close), medium (normal) and coarse (loose) series.

M18x1 thread dimensions

DimensionInchmm
Major diameter (basic)0.708718.00
Pitch diameter (basic)0.683117.35
Minor diameter, internal (basic)0.666016.92
Pitch0.03941.00

Metric fine (ISO), 1 mm pitch. Basic dimensions from the ISO 261 / ISO 68-1 formulas.

Same size, other threads

What you'll need

M18 x 1 tapPlug tap for through holes, bottoming tap for blind holes
17 mm drill bit0.6693 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other metric tap drill sizes

What size drill for an M18x1 tap? Use a 17 mm drill for an M18 x 1 tap (77% thread). The closest inch drill is 43/64 (0.6719 in, 72% thread).
M18x1 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for an M18x1 tap?

17.00 mm (0.6693 in). That is the major diameter minus the pitch (18 − 1 mm) and gives about 77% thread.

Can I use an inch drill for an M18x1 tap?

Yes: 43/64 in drill (0.6719 in, 17.07 mm) gives about 72% thread.

What is the clearance hole for an M18 bolt?

ISO 273: close fit 19.00 mm, normal fit 20.00 mm, loose fit 21.00 mm.

What does M18 x 1 mean?

An 18 mm nominal diameter ISO metric thread with a 1 mm pitch (fine series).