What size drill for a 3/4-10 tap?

Short answer: 21/32 in drill (0.6563 in, 16.67 mm). About 72% thread. Metric: 16.50 mm (77%).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
3/4-10 tapped hole drawn to scale: drill 21/32, thread major diameter 19.05 mm1/2 in
21/32"21/32 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.6563
Millimetres
16.67
Thread
72%
Download PDF chartShared link keeps your settings: 75% thread, all inch drills

3/4-10 tap drill sizes from 50% to 85% thread

DrillInchmmThread
43/64"0.671917.0760%
21/32"Recommended0.656316.6772%
41/64"0.640616.2784%

Recommended: the standard drill nearest to 75% thread. Thread dimensions per ASME B1.1. How we calculate

Clearance hole for a 3/4 screw

FitDrillInchmm
Close51/64"0.796920.24
Normal27/32"0.843821.43
Loose57/64"0.890622.62

Smallest standard inch drill that gives the ISO 273 allowance for the same diameter (close = fine, normal = medium, loose = coarse).

3/4-10 thread dimensions

DimensionInchmm
Major diameter (basic)0.750019.05
Pitch diameter (basic)0.685017.40
Minor diameter, internal (basic)0.641716.30
Pitch (1/10 in)0.10002.54

Unified National Coarse (UNC), 10 threads per inch. Basic dimensions from the ASME B1.1 formulas.

Same size, other threads

What you'll need

3/4-10 UNC tapPlug tap for through holes, bottoming tap for blind holes
21/32 in drill bit0.6563 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other UNC tap drill sizes

What size drill for a 3/4-10 tap? Use a 21/32 in drill — 0.6563 in (16.67 mm) — for about 72% thread.
3/4-10 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 3/4-10 tap?

21/32 in drill (0.6563 in, 16.67 mm), about 72% thread.

What metric drill can I use for a 3/4-10 tap?

16.50 mm gives about 77% thread.

What is the clearance hole for a 3/4 screw?

Close fit: 51/64 in (0.7969 in); Normal fit: 27/32 in (0.8438 in); Loose fit: 57/64 in (0.8906 in).

What does 3/4-10 mean?

3/4 in major diameter with 10 threads per inch, Unified National Coarse (UNC).