What size drill for a 10-24 tap?

Short answer: #25 drill (0.1495 in, 3.80 mm). About 75% thread. Closest fractional drill: 5/32 in (62% thread). Metric: 3.80 mm (75%).

Your tap

Thread engagement
Drills you have

75% thread is the usual chart value. A lower percentage means a slightly bigger hole and easier tapping in hard or stainless steel. Percent of thread = (major diameter − drill) ÷ (1.299 × pitch).

Use this drill
10-24 tapped hole drawn to scale: drill #25, thread major diameter 4.83 mm1/8 in
#25#25 drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.1495
Millimetres
3.80
Thread
75%
Download PDF chartShared link keeps your settings: 75% thread, all inch drills

10-24 tap drill sizes from 50% to 85% thread

DrillInchmmThread
#200.16104.0954%
#210.15904.0457%
#220.15703.9961%
5/32"0.15633.9762%
#230.15403.9167%
#240.15203.8670%
#25Recommended0.14953.8075%
#260.14703.7379%
#270.14403.6685%

Recommended: the standard drill nearest to 75% thread. Thread dimensions per ASME B1.1. How we calculate

Clearance hole for a #10 screw

FitDrillInchmm
Close13/64"0.20315.16
Normal#30.21305.41
Loose#10.22805.79

Smallest standard inch drill that gives the ISO 273 allowance for the same diameter (close = fine, normal = medium, loose = coarse).

10-24 thread dimensions

DimensionInchmm
Major diameter (basic)0.19004.83
Pitch diameter (basic)0.16294.14
Minor diameter, internal (basic)0.14493.68
Pitch (1/24 in)0.04171.06

Unified National Coarse (UNC), 24 threads per inch. Basic dimensions from the ASME B1.1 formulas.

Same size, other threads

What you'll need

10-24 UNC tapPlug tap for through holes, bottoming tap for blind holes
#25 drill bit0.1495 in tap drill
Tap wrenchT-handle for small taps, bar wrench for large
Cutting oilNot needed for brass or cast iron

Other UNC tap drill sizes

What size drill for a 10-24 tap? Use a #25 drill — 0.1495 in (3.80 mm) — for about 75% thread. The closest fractional drill is 5/32 in (62% thread).
10-24 tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 10-24 tap?

#25 drill (0.1495 in, 3.80 mm), about 75% thread. Fractional alternative: 5/32 in (62% thread).

What metric drill can I use for a 10-24 tap?

3.80 mm gives about 75% thread.

What is the clearance hole for a #10 screw?

Close fit: 13/64 in (0.2031 in); Normal fit: #3 (0.2130 in); Loose fit: #1 (0.2280 in).

What does 10-24 mean?

#10 screw size (0.1900 in major diameter) with 24 threads per inch, Unified National Coarse (UNC).