What size drill for a 1/2 NPT tap?

Short answer: 23/32 in drill (0.7188 in, 18.26 mm). Drill, then tap with a 1/2-14 NPT pipe tap (no reaming).

1/2 NPT pipe thread

Pipe outside diameter (D)
0.8400 in
Hand-tight engagement (L1)
0.3200 in
Effective thread length (L2)
0.5337 in
Threads per inch
14

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
1/2 NPT tapped hole drawn to scale: drill 23/32, thread major diameter 21.34 mm1/2 in
23/32"23/32 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.7188
Millimetres
18.26

1/2 NPT tap drill and nearby drills

DrillInchmm
3/4"0.750019.05
47/64"0.734418.65
23/32"Recommended0.718818.26
45/64"0.703117.86
11/16"0.687517.46

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

1/2 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)0.840021.34
Threads per inch (pitch in mm)141.81
Pitch diameter at pipe end (E0)0.758419.26
Pitch diameter at gauge plane (E1)0.778419.77
Hand-tight engagement (L1)0.32008.13
Effective thread length (L2)0.533713.56
Thread height (h = 0.8p)0.05711.45
Minor diameter at gauge plane (E1 − h)0.721318.32

National Pipe Taper (NPT), 14 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

1/2 NPT pipe tapTaper pipe tap, same size as the fitting
23/32 in drill bit0.7188 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 1/2 NPT tap? Use a 23/32 in drill — 0.7188 in (18.26 mm) — for a 1/2 NPT pipe tap without reaming.
1/2 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 1/2 NPT tap?

23/32 in (0.7188 in, 18.26 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (0.7213 in).

Is 1/2 NPT really 1/2 inch?

No. Pipe sizes are nominal. 1/2 NPT fits pipe with an outside diameter of 0.8400 in (21.34 mm) and has 14 threads per inch.

How deep do 1/2 NPT threads engage?

Hand-tight engagement (L1) is 0.3200 in; the effective thread length (L2) is 0.5337 in (ASME B1.20.1).