What size drill for a 3/4 NPT tap?

Short answer: 59/64 in drill (0.9219 in, 23.42 mm). Drill, then tap with a 3/4-14 NPT pipe tap (no reaming).

3/4 NPT pipe thread

Pipe outside diameter (D)
1.0500 in
Hand-tight engagement (L1)
0.3390 in
Effective thread length (L2)
0.5457 in
Threads per inch
14

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
3/4 NPT tapped hole drawn to scale: drill 59/64, thread major diameter 26.67 mm1/2 in
59/64"59/64 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.9219
Millimetres
23.42

3/4 NPT tap drill and nearby drills

DrillInchmm
61/64"0.953124.21
15/16"0.937523.81
59/64"Recommended0.921923.42
29/32"0.906323.02
57/64"0.890622.62

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

3/4 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)1.050026.67
Threads per inch (pitch in mm)141.81
Pitch diameter at pipe end (E0)0.967724.58
Pitch diameter at gauge plane (E1)0.988925.12
Hand-tight engagement (L1)0.33908.61
Effective thread length (L2)0.545713.86
Thread height (h = 0.8p)0.05711.45
Minor diameter at gauge plane (E1 − h)0.931723.67

National Pipe Taper (NPT), 14 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

3/4 NPT pipe tapTaper pipe tap, same size as the fitting
59/64 in drill bit0.9219 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 3/4 NPT tap? Use a 59/64 in drill — 0.9219 in (23.42 mm) — for a 3/4 NPT pipe tap without reaming.
3/4 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 3/4 NPT tap?

59/64 in (0.9219 in, 23.42 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (0.9317 in).

Is 3/4 NPT really 3/4 inch?

No. Pipe sizes are nominal. 3/4 NPT fits pipe with an outside diameter of 1.0500 in (26.67 mm) and has 14 threads per inch.

How deep do 3/4 NPT threads engage?

Hand-tight engagement (L1) is 0.3390 in; the effective thread length (L2) is 0.5457 in (ASME B1.20.1).