What size drill for a 1/4 NPT tap?

Short answer: 7/16 in drill (0.4375 in, 11.11 mm). Drill, then tap with a 1/4-18 NPT pipe tap (no reaming).

1/4 NPT pipe thread

Pipe outside diameter (D)
0.5400 in
Hand-tight engagement (L1)
0.2278 in
Effective thread length (L2)
0.4018 in
Threads per inch
18

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
1/4 NPT tapped hole drawn to scale: drill 7/16, thread major diameter 13.72 mm1/4 in
7/16"7/16 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.4375
Millimetres
11.11

1/4 NPT tap drill and nearby drills

DrillInchmm
15/32"0.468811.91
29/64"0.453111.51
7/16"Recommended0.437511.11
27/64"0.421910.72
13/32"0.406310.32

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

1/4 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)0.540013.72
Threads per inch (pitch in mm)181.41
Pitch diameter at pipe end (E0)0.477412.13
Pitch diameter at gauge plane (E1)0.491612.49
Hand-tight engagement (L1)0.22785.79
Effective thread length (L2)0.401810.21
Thread height (h = 0.8p)0.04441.13
Minor diameter at gauge plane (E1 − h)0.447211.36

National Pipe Taper (NPT), 18 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

1/4 NPT pipe tapTaper pipe tap, same size as the fitting
7/16 in drill bit0.4375 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 1/4 NPT tap? Use a 7/16 in drill — 0.4375 in (11.11 mm) — for a 1/4 NPT pipe tap without reaming.
1/4 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 1/4 NPT tap?

7/16 in (0.4375 in, 11.11 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (0.4472 in).

Is 1/4 NPT really 1/4 inch?

No. Pipe sizes are nominal. 1/4 NPT fits pipe with an outside diameter of 0.5400 in (13.72 mm) and has 18 threads per inch.

How deep do 1/4 NPT threads engage?

Hand-tight engagement (L1) is 0.2278 in; the effective thread length (L2) is 0.4018 in (ASME B1.20.1).