What size drill for a 1/8 NPT tap?

Short answer: 11/32 in drill (0.3438 in, 8.73 mm). Drill, then tap with a 1/8-27 NPT pipe tap (no reaming).

1/8 NPT pipe thread

Pipe outside diameter (D)
0.4050 in
Hand-tight engagement (L1)
0.1615 in
Effective thread length (L2)
0.2639 in
Threads per inch
27

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
1/8 NPT tapped hole drawn to scale: drill 11/32, thread major diameter 10.29 mm1/4 in
11/32"11/32 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.3438
Millimetres
8.73

1/8 NPT tap drill and nearby drills

DrillInchmm
3/8"0.37509.53
23/64"0.35949.13
11/32"Recommended0.34388.73
21/64"0.32818.33
5/16"0.31257.94

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

1/8 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)0.405010.29
Threads per inch (pitch in mm)270.94
Pitch diameter at pipe end (E0)0.36359.23
Pitch diameter at gauge plane (E1)0.37369.49
Hand-tight engagement (L1)0.16154.10
Effective thread length (L2)0.26396.70
Thread height (h = 0.8p)0.02960.75
Minor diameter at gauge plane (E1 − h)0.34408.74

National Pipe Taper (NPT), 27 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

1/8 NPT pipe tapTaper pipe tap, same size as the fitting
11/32 in drill bit0.3438 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 1/8 NPT tap? Use an 11/32 in drill — 0.3438 in (8.73 mm) — for a 1/8 NPT pipe tap without reaming.
1/8 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 1/8 NPT tap?

11/32 in (0.3438 in, 8.73 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (0.3440 in).

Is 1/8 NPT really 1/8 inch?

No. Pipe sizes are nominal. 1/8 NPT fits pipe with an outside diameter of 0.4050 in (10.29 mm) and has 27 threads per inch.

How deep do 1/8 NPT threads engage?

Hand-tight engagement (L1) is 0.1615 in; the effective thread length (L2) is 0.2639 in (ASME B1.20.1).