What size drill for a 1 NPT tap?

Short answer: 1-5/32 in drill (1.1563 in, 29.37 mm). Drill, then tap with a 1-11.5 NPT pipe tap (no reaming).

1 NPT pipe thread

Pipe outside diameter (D)
1.3150 in
Hand-tight engagement (L1)
0.4000 in
Effective thread length (L2)
0.6828 in
Threads per inch
11.5

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
1 NPT tapped hole drawn to scale: drill 1-5/32, thread major diameter 33.40 mm1 in
1-5/32"1-5/32 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.1563
Millimetres
29.37

1 NPT tap drill and nearby drills

DrillInchmm
1-3/16"1.187530.16
1-11/64"1.171929.77
1-5/32"Recommended1.156329.37
1-9/64"1.140628.97
1-1/8"1.125028.58

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

1 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)1.315033.40
Threads per inch (pitch in mm)11.52.21
Pitch diameter at pipe end (E0)1.213630.83
Pitch diameter at gauge plane (E1)1.238631.46
Hand-tight engagement (L1)0.400010.16
Effective thread length (L2)0.682817.34
Thread height (h = 0.8p)0.06961.77
Minor diameter at gauge plane (E1 − h)1.169129.69

National Pipe Taper (NPT), 11.5 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

1 NPT pipe tapTaper pipe tap, same size as the fitting
1-5/32 in drill bit1.1563 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 1 NPT tap? Use a 1-5/32 in drill — 1.1563 in (29.37 mm) — for a 1 NPT pipe tap without reaming.
1 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 1 NPT tap?

1-5/32 in (1.1563 in, 29.37 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (1.1691 in).

Is 1 NPT really 1 inch?

No. Pipe sizes are nominal. 1 NPT fits pipe with an outside diameter of 1.3150 in (33.40 mm) and has 11.5 threads per inch.

How deep do 1 NPT threads engage?

Hand-tight engagement (L1) is 0.4000 in; the effective thread length (L2) is 0.6828 in (ASME B1.20.1).