What size drill for a 2 NPT tap?

Short answer: 2-7/32 in drill (2.2188 in, 56.36 mm). Drill, then tap with a 2-11.5 NPT pipe tap (no reaming).

2 NPT pipe thread

Pipe outside diameter (D)
2.3750 in
Hand-tight engagement (L1)
0.4360 in
Effective thread length (L2)
0.7565 in
Threads per inch
11.5

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
2 NPT tapped hole drawn to scale: drill 2-7/32, thread major diameter 60.33 mm1 in
2-7/32"2-7/32 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
2.2188
Millimetres
56.36

2 NPT tap drill and nearby drills

DrillInchmm
2-1/4"2.250057.15
2-15/64"2.234456.75
2-7/32"Recommended2.218856.36
2-13/64"2.203155.96
2-3/16"2.187555.56

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

2 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)2.375060.33
Threads per inch (pitch in mm)11.52.21
Pitch diameter at pipe end (E0)2.269057.63
Pitch diameter at gauge plane (E1)2.296358.33
Hand-tight engagement (L1)0.436011.07
Effective thread length (L2)0.756519.22
Thread height (h = 0.8p)0.06961.77
Minor diameter at gauge plane (E1 − h)2.226756.56

National Pipe Taper (NPT), 11.5 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

2 NPT pipe tapTaper pipe tap, same size as the fitting
2-7/32 in drill bit2.2188 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 2 NPT tap? Use a 2-7/32 in drill — 2.2188 in (56.36 mm) — for a 2 NPT pipe tap without reaming.
2 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 2 NPT tap?

2-7/32 in (2.2188 in, 56.36 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (2.2267 in).

Is 2 NPT really 2 inch?

No. Pipe sizes are nominal. 2 NPT fits pipe with an outside diameter of 2.3750 in (60.33 mm) and has 11.5 threads per inch.

How deep do 2 NPT threads engage?

Hand-tight engagement (L1) is 0.4360 in; the effective thread length (L2) is 0.7565 in (ASME B1.20.1).