What size drill for a 1/16 NPT tap?

Short answer: 1/4 in drill (0.2500 in, 6.35 mm). Drill, then tap with a 1/16-27 NPT pipe tap (no reaming).

1/16 NPT pipe thread

Pipe outside diameter (D)
0.3125 in
Hand-tight engagement (L1)
0.1600 in
Effective thread length (L2)
0.2611 in
Threads per inch
27

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
1/16 NPT tapped hole drawn to scale: drill 1/4, thread major diameter 7.94 mm1/4 in
1/4"1/4 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
0.2500
Millimetres
6.35

1/16 NPT tap drill and nearby drills

DrillInchmm
9/32"0.28137.14
17/64"0.26566.75
1/4"Recommended0.25006.35
15/64"0.23445.95
7/32"0.21885.56

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

1/16 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)0.31257.94
Threads per inch (pitch in mm)270.94
Pitch diameter at pipe end (E0)0.27126.89
Pitch diameter at gauge plane (E1)0.28127.14
Hand-tight engagement (L1)0.16004.06
Effective thread length (L2)0.26116.63
Thread height (h = 0.8p)0.02960.75
Minor diameter at gauge plane (E1 − h)0.25166.39

National Pipe Taper (NPT), 27 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

1/16 NPT pipe tapTaper pipe tap, same size as the fitting
1/4 in drill bit0.2500 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 1/16 NPT tap? Use a 1/4 in drill — 0.2500 in (6.35 mm) — for a 1/16 NPT pipe tap without reaming.
1/16 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 1/16 NPT tap?

1/4 in (0.2500 in, 6.35 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (0.2516 in).

Is 1/16 NPT really 1/16 inch?

No. Pipe sizes are nominal. 1/16 NPT fits pipe with an outside diameter of 0.3125 in (7.94 mm) and has 27 threads per inch.

How deep do 1/16 NPT threads engage?

Hand-tight engagement (L1) is 0.1600 in; the effective thread length (L2) is 0.2611 in (ASME B1.20.1).