What size drill for a 1-1/2 NPT tap?

Short answer: 1-3/4 in drill (1.7500 in, 44.45 mm). Drill, then tap with a 1-1/2-11.5 NPT pipe tap (no reaming).

1-1/2 NPT pipe thread

Pipe outside diameter (D)
1.9000 in
Hand-tight engagement (L1)
0.4200 in
Effective thread length (L2)
0.7235 in
Threads per inch
11.5

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
1-1/2 NPT tapped hole drawn to scale: drill 1-3/4, thread major diameter 48.26 mm1 in
1-3/4"1-3/4 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.7500
Millimetres
44.45

1-1/2 NPT tap drill and nearby drills

DrillInchmm
1-25/32"1.781345.24
1-49/64"1.765644.85
1-3/4"Recommended1.750044.45
1-47/64"1.734444.05
1-23/32"1.718843.66

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

1-1/2 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)1.900048.26
Threads per inch (pitch in mm)11.52.21
Pitch diameter at pipe end (E0)1.796145.62
Pitch diameter at gauge plane (E1)1.822346.29
Hand-tight engagement (L1)0.420010.67
Effective thread length (L2)0.723518.38
Thread height (h = 0.8p)0.06961.77
Minor diameter at gauge plane (E1 − h)1.752844.52

National Pipe Taper (NPT), 11.5 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

1-1/2 NPT pipe tapTaper pipe tap, same size as the fitting
1-3/4 in drill bit1.7500 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 1-1/2 NPT tap? Use a 1-3/4 in drill — 1.7500 in (44.45 mm) — for a 1-1/2 NPT pipe tap without reaming.
1-1/2 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 1-1/2 NPT tap?

1-3/4 in (1.7500 in, 44.45 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (1.7528 in).

Is 1-1/2 NPT really 1-1/2 inch?

No. Pipe sizes are nominal. 1-1/2 NPT fits pipe with an outside diameter of 1.9000 in (48.26 mm) and has 11.5 threads per inch.

How deep do 1-1/2 NPT threads engage?

Hand-tight engagement (L1) is 0.4200 in; the effective thread length (L2) is 0.7235 in (ASME B1.20.1).