What size drill for a 1-1/4 NPT tap?

Short answer: 1-1/2 in drill (1.5000 in, 38.10 mm). Drill, then tap with a 1-1/4-11.5 NPT pipe tap (no reaming).

1-1/4 NPT pipe thread

Pipe outside diameter (D)
1.6600 in
Hand-tight engagement (L1)
0.4200 in
Effective thread length (L2)
0.7068 in
Threads per inch
11.5

Pipe tap drill charts vary by up to 1/32 in for sizes over 1 in. Reaming the drilled hole with a taper pipe reamer before tapping lowers tapping torque.

Use this drill
1-1/4 NPT tapped hole drawn to scale: drill 1-1/2, thread major diameter 42.16 mm1 in
1-1/2"1-1/2 in drillDrawn to scale. Copper ring: thread depth the tap cuts.
Decimal inch
1.5000
Millimetres
38.10

1-1/4 NPT tap drill and nearby drills

DrillInchmm
1-17/32"1.531338.89
1-33/64"1.515638.50
1-1/2"Recommended1.500038.10
1-31/64"1.484437.70
1-15/32"1.468837.31

Recommended: largest 1/64 in drill not over the minor diameter at the gauge plane (ASME B1.20.1). How we calculate

1-1/4 NPT thread dimensions

DimensionInchmm
Pipe outside diameter (D)1.660042.16
Threads per inch (pitch in mm)11.52.21
Pitch diameter at pipe end (E0)1.557139.55
Pitch diameter at gauge plane (E1)1.583440.22
Hand-tight engagement (L1)0.420010.67
Effective thread length (L2)0.706817.95
Thread height (h = 0.8p)0.06961.77
Minor diameter at gauge plane (E1 − h)1.513838.45

National Pipe Taper (NPT), 11.5 threads per inch. Basic dimensions from the ASME B1.20.1 formulas.

What you'll need

1-1/4 NPT pipe tapTaper pipe tap, same size as the fitting
1-1/2 in drill bit1.5000 in tap drill
Tap wrench (T-handle or bar)Sized for the tap shank
Cutting oilFor steel, stainless and cast iron

Other NPT tap drill sizes

What size drill for a 1-1/4 NPT tap? Use a 1-1/2 in drill — 1.5000 in (38.10 mm) — for a 1-1/4 NPT pipe tap without reaming.
1-1/4 NPT tap drill chart as a pictureThe same numbers as on this page, as one picture you can save. The printable 1:1 chart is the PDF above.

Questions

What size drill bit for a 1-1/4 NPT tap?

1-1/2 in (1.5000 in, 38.10 mm), the largest 1/64 in drill not larger than the thread's minor diameter at the gauge plane (1.5138 in).

Is 1-1/4 NPT really 1-1/4 inch?

No. Pipe sizes are nominal. 1-1/4 NPT fits pipe with an outside diameter of 1.6600 in (42.16 mm) and has 11.5 threads per inch.

How deep do 1-1/4 NPT threads engage?

Hand-tight engagement (L1) is 0.4200 in; the effective thread length (L2) is 0.7068 in (ASME B1.20.1).